Measuring Process

Once switched on, the measuring tool is in the length measurement function.

Once the measuring tool has been switched on, the rear edge of the measuring tool is selected as the reference level for measurement. You can change the reference level. see Selecting the Reference Level

  1. Apply the measuring tool to the point at which you want to start the measurement (e.g. wall).
  2. Press the  button to start the measurement.

Once the measurement process is complete, the laser beam will switch off. For a further measurement, repeat this process.

Measured values or end results can be added or subtracted.

The measured value typically appears within 0.5 s and at the latest after approx. 4 s.

The duration of the measurement depends on the distance, the lighting conditions and the reflective properties of the target surface. Once the measurement process is complete, the laser beam will automatically switch off.

With a switched-on permanent laser beam and in the continuous measurement function, the measurement begins immediately after the first press of the  button.

The switched-on permanent laser beam is not switched off after the measurement  see Permanent Laser Beam .

The measuring tool must not be moved during a measurement. Therefore, place the measuring tool, as far as this is possible, against or on a firm stop or supporting surface.
The reception lens (20), the laser beam output (21) and the camera (22) must not be covered during the measuring process.

Influences on the Measuring Range

The measuring range depends on the lighting conditions and the reflective properties of the target surface.

For better visibility of the laser beam in strong foreign light, use the integrated camera (22), the laser viewing glasses (29) (accessory) and the laser target plate (28) (accessory), or shade the target surface.

Influences on the Measurement Result

Due to physical effects, incorrect measurements are possible when measuring on various surfaces. These include:

  • Transparent surfaces (e.g. glass, water)
  • Reflective surfaces (e.g. polished metal, glass)
  • Porous surfaces (e.g. insulation materials)
  • Structured surfaces (e.g. roughcast, natural stone)

If necessary, use the laser target plate (28) (accessory) on these surfaces.

Incorrect measurements are also possible on slanted target surfaces.

Likewise, layers of air with different temperatures or indirectly received reflections can influence the measured value.