Changing the Tool
- Before carrying out any work on the power tool (e.g. maintenance, tool change etc.), remove the battery from the power tool. There is risk of injury from unintentionally pressing the on/off switch.
- Regularly clean the power tool’s air vents. The motor’s fan can draw the dust inside the housing and excessive accumulation of powdered metal may cause electrical hazards.
Pull the locking sleeve (2) forward, guide the application tool (1) into the tool holder up to the stop and release the locking sleeve (2) to lock the application tool.
Impact-proof screwdriver bits (17) can be inserted using a universal bit holder (16) with ball catch.
Impact-proof screwdriver bits (17) can be inserted using a universal bit holder with ball catch (16).
- When fitting an application tool, make sure that it is held securely in the tool holder. If the application tool is not held securely in the tool holder, it may become loose and consequently uncontrollable.
Slide the application tool (18) onto the square drive of the tool holder (1).
Due to the way the system operates, the application tool (18) will move around slightly in the tool holder (1); this has no influence on the function/safety.
Some application tools (e.g. double bits) cannot be safely secured in the tool holder.