Battery Charging (see figure A)

For charging, use the recommended USB power supply unit or a power supply unit with 5 V and at least 1.0 A. Observe the operating manual of the USB power supply unit.
Recommended power supply unit: See "Technical Data" section.

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power adaptor. Power adaptors marked with 230 V can also be operated with 220 V.

Note: Lithium-ion rechargeable batteries are supplied partially charged according to international transport regulations. To ensure full rechargeable battery capacity, fully charge the rechargeable battery before using your tool for the first time.

To charge the battery, connect the USB charging socket to the power supply via the USB cable. Plug the power supply into a plug socket.

Do not continue to apply pressure to the spindle after the power tool has automatically switched itself off. This can damage the battery.

Do not continue to press the On/Off switch after the power tool has automatically switched off. The battery can be damaged.

The battery charge indicator (8) is also the worklight. The display shows the charging progress. During the charging procedure, the indicator flashes. When the battery is charged, the battery charge indicator (8) lights up continuously.

During the charging process, the handle of the power tool will heat up. This is normal. If you are not planning to use the power tool again soon, disconnect the charger from the mains. The power tool cannot be used during the charging process. It is not defective if it does not work during the charging process. Follow the instructions on correct disposal.