Starting Operation
- Pay attention to the mains voltage! The voltage of the power source must match the voltage specified on the rating plate of the power tool. Power tools marked with 230 V can also be operated with 220 V.
- Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.
Setting the rotational direction
- Only operate the rotational direction switch (5) when the power tool is not in use.
The rotational direction switch (5) is used to change the rotational direction of the power tool.
Right rotation: Slide the rotational direction switch (5) all the way down (R).
Left rotation: Slide the rotational direction switch (5) all the way up (L).
Switching on/off
To start, press the on/off switch (4) and keep it pressed.
To switch off, release the on/off switch (4).