Work Position (see figure 
A)
If the power tool is as delivered, or the power tool was used as a table saw, you must complete the following steps before using it as a mitre saw:
- Loosen both clamping levers (68) under the saw table (59).
- Pull the saw table upwards as far as it will go.
- Hold the saw table in this position and retighten the clamping lever.
- Position the parallel guide (61) as protection over the saw blade.
- Press the tool arm down slightly by the handle (18) to release the transport safety lock (38).
- Pull the transport safety lock (38) all the way out.
- Remove the lower saw blade cover (66) and push it into the groove on the right-hand side of the parallel guide (61).
- Do not throw away the lower saw blade cover! It is not possible to operate the combination saw as a table saw without the lower saw blade cover attached!
- Slowly guide the tool arm upwards.
- Loosen the locking screw (44).
- Push the adjustable fence (31) fully in.
- Retighten the locking screw (44).