Preparing for operation

The free end of long workpieces must have something placed underneath it or be supported.

The saw table can be extended left and right using the saw table extensions (29).

  • Loosen the clamping screw (18).
  • Pull out the saw table extension (29) to the required length.
  • Retighten the clamping screw (18) to fix the saw table extension.

 

When sawing mitre and/or bevel angles, you have to pull the left-hand or right-hand adjustable fence (2) outwards depending on the cutting direction, or remove it completely.

If necessary, reinstall the adjustable fence (2) after making the cut.

Vertical bevel angle range

–2° to +40°

Left

  • Loosen the locking screw (38).
  • Pull the adjustable fence (2) all the way out.

–2° to +35°

Right

> 40°

Left

  • Loosen the locking screw (38).
  • Pull the adjustable fence (2) all the way out.
  • Lift the adjustable fence upwards and out of the way.

> 35°

Right

Horizontal bevel angle range

> 45°

Left

  • Loosen the locking screw (38).
  • Pull the adjustable fence (2) all the way out.

Right

To ensure maximum safety while working, the workpiece must always be firmly clamped.
Do not saw workpieces that are too small to clamp firmly.

  • Press the workpiece firmly against the fences (1) and (2).
  • Insert the supplied screw clamp (40) into one of the corresponding holes (31).
  • Loosen the wing bolt (52) and adjust the screw clamp to the workpiece. Tighten the wing bolt again.
  • Tighten the threaded rod (51) to fix the workpiece in place.

Releasing the workpiece

  • To loosen the screw clamp, turn the threaded rod (51) anticlockwise.