Battery charge indicator

Note: Not all battery types have a battery charge indicator.

The green LEDs on the battery charge indicator indicate the state of charge of the battery. For safety reasons, it is only possible to check the state of charge when the power tool is not in operation.

Press the button for the battery charge indicator  or to show the state of charge. This is also possible when the battery is removed.

If no LED lights up after pressing the button for the battery charge indicator, then the battery is defective and must be replaced.

LED

Capacity

3× continuous green light

60–100 %

2× continuous green light

30–60 %

1× continuous green light

5–30 %

1× flashing green light

0–5 %

 

LED

Capacity

5 × continuous green light

80–100 %

4 × continuous green light

60–80 %

3 × continuous green light

40–60 %

2 × continuous green light

20–40 %

1 × continuous green light

5–20 %

1 × flashing green light

0–5 %

The LED worklight (8) is used as a status indicator for device protection and low battery status:

LED
Feedback

Description

Flashing light 3x
during operation

Battery status is low.
The voltage level of the battery has fallen below the optimum value. The performance of the device is restricted.

Flashing light 3x
during downtime

Device protection is active.
Device protection has been activated to prevent the battery from consuming a large amount of power and to protect the device against damage.

  • If the battery status is low, charge the battery (6) or replace the weak battery with a fully charged battery.