Product features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
(1) | Drive unit |
(2) | Routing base |
(3) | Carbon brush bracket |
(4) | Nut for routing guide |
(5) | Chip deflector |
(6) | Knurled screw for routing base |
(7) | Router bitA) |
(8) | Cap nut with collet |
(9) | Guide plate |
(10) | Base plate |
(11) | Dust extraction adapter |
(12) | Wing bolt for routing base |
(13) | On/off switch |
(14) | Handle (insulated gripping surface) |
(15) | Scale for setting routing depth |
(16) | Collet |
(17) | Tool holder |
(18) | Open-ended spanner (10 mm)A) |
(19) | Open-ended spanner (17 mm)A) |
(20) | Guide bushingA) |
(21) | Parallel guideA) |
(22) | Wing bolt for parallel guideA) |
(23) | GuideA) |
(24) | Wing bolt for fixing horizontal alignmentA) |
(25) | Wing bolt for horizontal alignment of the guideA) |
(26) | Guide rollerA) |
(27) | Dust extraction adapterA) |
(28) | Extraction hoseA) |
- A)
Accessories shown or described are not included with the product as standard. You can find the complete selection of accessories in our accessories range.