Adjusting bevel angles
The bevel angle can be set between –2° (left-hand side) and +47° (right-hand side).
For quick and precise setting of frequently used bevel angles, fixed positions have been provided for the angles 0°, 22.5°, 33.9° and 45°.
Setting Standard Bevel Angles
- Loosen the clamping lever (39).
- Adjust the stops (29) or (42) as follows:
Bevel angle | Stop | Setting |
|---|---|---|
0° | (42) | Slide the stop all the way back |
45° | (29) | Turn the stop all the way to the front |
22.5° | (29) | Turn the stop to the centre |
33.9° | (29) | Turn the stop to the back |
- Swivel the tool arm by the handle (9) into the required position.
- Retighten the clamping lever (39).
Setting any bevel angle
- Loosen the clamping lever (39).
- Turn the stop (29) all the way to the back and pull the stop (42) all the way to the front.
The full swivel range is now available. - Swivel the tool arm left or right by the handle (9) until the angle indicator (41) shows the required bevel angle.
- Hold the tool arm in this position and retighten the clamping lever (39).