Power supply
The measuring tool can be operated either with conventional non-rechargeable batteries or with a Bosch lithium-ion battery.
Operation with battery adapter (removable) (see figures A and B)
The batteries are inserted into the battery adapter.
- The battery adapter is intended only for use in designated Bosch measuring tools and must not be used with power tools.
To insert the batteries, slide the receptacle (21) of the battery adapter into the battery bay (18). Place the batteries in the receptacle as shown in the picture on the cap (20). Push the cap over the receptacle until you feel it click into place.
To remove the batteries, press the release buttons (19) on the cap (20) and pull the cap off. Hold the measuring tool with the battery bay (18) facing upwards to ensure that the batteries do not fall out when you do this. Remove the batteries. To remove the receptacle (21) from inside the battery bay, reach into the receptacle and pull it out of the measuring tool, applying light pressure to the side wall as you do so.
Note: Do not use any tools (e.g. a screwdriver) to remove the battery, as this could break the cover.
Always replace all the batteries at the same time. Only use batteries from the same manufacturer and which have the same capacity.
- Take the batteries out of the measuring tool when you are not using it for a prolonged period of time. The batteries can corrode and self-discharge during prolonged storage in the measuring tool.
Operation with rechargeable battery (see figure C)
Note: The use of batteries unsuitable for your measuring tool can lead to malfunctions or damage to the measuring tool.
- Use only the chargers listed in the technical data. Only these chargers are matched to the lithium-ion battery of your measuring tool.
The lithium-ion battery can be charged at any time without reducing its service life. Interrupting the charging process does not damage the battery.
To insert the charged battery pack (23), slide it into the battery bay (18) until you feel it click into place and it is flush with the handle of the measuring tool.
To remove the battery pack (23), press the release buttons (19) and pull the battery pack out of the battery bay (18). Do not use force to do this.