Working with the RM 1 rotating mount (see figures A–B)

Using the rotating mount (13), you can rotate the measuring tool 360°. This enables you to set up the laser lines precisely, without having to change the position of the measuring tool.

Place the measuring tool with the guide groove (17) on the guide rail (14) of the rotating mount (13) and slide the measuring tool all the way onto the platform.
To disconnect the measuring tool, pull it off the rotating mount in the opposite direction.

Rotating mount positioning options:

Standing on a flat surface,
Screwed to a vertical surface,
On metallic ceiling strips using the ceiling clip (18),
On metallic surfaces using the magnets (16).

Keep your fingers away from the rear side of the magnetic accessory while attaching the accessory to surfaces. The strong pulling force of the magnets may jam your fingers.