Practical advice
- Do not touch the cutting disc after use until it has cooled. The cutting disc becomes very hot during use.
- Make sure that the spark guard plate (17) is fitted properly. Flying sparks are created when sanding metals.
Protect the cutting disc against impact, shock and grease. Do not subject the cutting disc to lateral pressure.
Do not load the power tool so heavily that it comes to a stop.
Excessive feed significantly reduces the performance of the power tool and the service life of the cutting disc.
Only use cutting discs that are suitable for the material being machined.
Maximum workpiece dimensions (in mm)
Workpiece shape | Mitre angle | |
|---|---|---|
0° | 45° | |
| Dia. 129 | Dia. 128 |
| 120 x 120 | 110 x 110 |
| 100 x 200 | 107 x 115 |
| 137 x 137 | 115 x 115 |
Minimum workpiece dimensions
(= all workpieces which can still be clamped in place with the locking spindle (7)): Length 80 mm
Maximum cutting depth (0°/0°): 129 mm
The dust from materials such as lead paint, minerals and metal can be harmful to human health. Touching or breathing in this dust can trigger allergic reactions and/or cause respiratory illnesses in the user or in people in the near vicinity.
Certain kinds of metal dust are hazardous, especially in combination with alloys such as zinc, aluminium or chrome. Materials containing asbestos may only be machined by specialists.
- Provide good ventilation at the workplace.
- It is advisable to wear a P2 filter class breathing mask.
The regulations on the materials being machined that apply in the country of use must be observed.
The cutting disc can become blocked by dust, chips or fragments of the workpiece in the recess of the base plate (11).
- Switch the power tool off and pull the mains plug out of the socket.
- Wait until the cutting disc has come to a complete stop.
- Tilt the power tool backwards so that small pieces of the workpiece can fall out of the opening designed for this purpose.
If necessary, use a suitable tool to remove all the pieces of workpiece.
- Avoid dust accumulation at the workplace. Dust can easily ignite.
- Set the required mitre angle as necessary.
- Firmly clamp the workpiece as appropriate for its dimensions.
- Switch on the power tool.
- Slowly guide the tool arm downwards using the handle (2).
- Cut the workpiece, applying uniform feed.
- Switch off the power tool and wait until the cutting disc has come to a complete stop.
- Slowly guide the tool arm upwards.