Fitting Protective Equipment
- Pull the plug out of the socket before carrying out any work on the power tool.
Note: If the grinding disc breaks during operation or the holding fixtures on the protective guard/power tool become damaged, the power tool must be sent to the after-sales service immediately; see the "After-Sales Service and Application Service" section for addresses.
Open the clamping lever . Place the protective guard with the coding cam engaging into the coding groove on the spindle collar until the shoulder of the protective guard is seated against the flange of the power tool, and turn the protective guard to the required position. Close the clamping lever .
- Adjust the protective guard such that sparking in the direction of the operator is prevented.
The tensioning force of the clamp from the protective guard can be changed by loosening or tightening the adjustment screw . Ensure that the protective guard is fitted securely and check it regularly.
Note: The coding cams on the protective guard ensure that only a protective guard that is suitable for the power tool can be fitted.
- Always use the protective guard for cutting when cutting with bonded abrasives.
- Provide sufficient dust extraction when cutting stone.
The protective guard for cutting is fitted in the same way as the protective guard for grinding with locking screw or the protective guard for grinding with clamping lever .