Product Features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
(1) | Slide device |
(2) | Chip ejector |
(3) | Transport handle |
(4) | Depth stop adjusting screw |
(5) | Guide roller |
(6) | Cover for GCY 42 Bluetooth® Low Energy Module |
(7) | Lock-off function for on/off switch |
(8) | On/off switch |
(9) | Handle |
(10) | Laser protection cap |
(11) | Protective guard |
(12) | Retracting blade guard |
(13) | Saw blade |
(14) | Saw table extension |
(15) | Fence |
(16) | Adjustable fence |
(17) | Saw table |
(18) | Clamping lever of the saw table extension |
(19) | Scale for mitre angles |
(20) | Insert plate |
(21) | Locking clamp |
(22) | Locking knob for various mitre angles |
(23) | Mitre pre-setting lever |
(24) | Tilt protector |
(25) | Laser warning label |
(26) | Angle indicator for mitre angles |
(27) | Detents for standard mitre angles |
(28) | Mounting holes |
(29) | Recessed handles |
(30) | Screw clamp |
(31) | Standard bevel angle stops 45°, 22.5° and 33.9° |
(32) | Scale for bevel angle |
(33) | Angle indicator for right-hand bevel angle range |
(34) | Clamping handle for various bevel angles |
(35) | Depth stop |
(36) | Locking screw for slide device |
(37) | User interface |
(38) | Transport safety lock |
(39) | Rechargeable batteryA) |
(40) | Rechargeable Battery release buttonA) |
(41) | Angle indicator for left-hand bevel angle range |
(42) | Chip deflector |
(43) | Stop for standard 0° bevel angle |
(44) | Hex key (5 mm/2.5 mm) |
(45) | Holes for screw clamp |
(46) | Length stop |
(47) | Locking screw for length stop |
(48) | Clamping screw for length stop |
(49) | Temperature indicator (user interface) |
(50) | ECO mode indicator (user interface) |
(51) | Power tool status indicator (user interface) |
(52) | Laser indicator (user interface) |
(53) | Worklight indicator (user interface) |
(54) | Laser/worklight on/off button (user interface) |
(55) | Speed setting/mode indicator (user interface) |
(56) | Speed preselection button (user interface) |
(57) | Dust bagA) |
(58) | Spindle lock |
(59) | Hex socket screw for mounting the saw blade |
(60) | Clamping flange |
(61) | Laser beam outlet aperture |
(62) | Inner clamping flange |
(63) | SDS bolt |
(64) | Locking screw for the adjustable fence |
(65) | Threaded rod |
(66) | Screws for insert plate |
(67) | Screws for laser protection cap |
(68) | Set screws for positioning the laser |
(69) | Screw for bevel angle indicator |
(70) | Stop screw for 0° bevel angle |
(71) | Stop screw for left-hand bevel angle range |
(72) | Stop screw for right-hand bevel angle range |
(73) | Set screws for mitre angle scale |
(74) | Screw for mitre angle indicator |
- A)
Accessories shown or described are not included with the product as standard. You can find the complete selection of accessories in our accessories range.