Preparing for operation

To ensure precise cuts, the basic settings of the power tool must be checked and adjusted as necessary after intensive use.
Experience and suitable special tools are required for this.

A Bosch after-sales service point will handle this work quickly and reliably.

The free end of long workpieces must have something placed underneath it or be supported.

The saw table can be extended left and right using the saw table extensions (14).

  • Pull the clamping lever (18) upwards.
  • Pull out the saw table extension (14) to the required length.
  • To lock the saw table extension, push the clamping lever (18) back down.

When sawing mitre and/or bevel angles, you have to pull the left-hand or right-hand adjustable fence (16) outwards depending on the cutting direction, or remove it completely.

Bevel angle

Mitre angle

0°–47°
(left)

≤ 44°
(right/left)
  • Loosen the locking screw (64).
  • Pull the left-hand adjustable fence (16) all the way out.

0°–47°
(left)

≥ 45°
(right/left)

  • Loosen the locking screw (64).
  • Pull the left-hand adjustable fence (16) all the way out.
  • Lift the adjustable fence upwards and out of the way.
  • Remove the locking screw (64).

0°–47°
(right)

≤ 44°
(right/left)

  • Loosen the locking screw (64).
  • Pull the right-hand adjustable fence (16) all the way out.
  • Lift the adjustable fence upwards and out of the way.

0°–47°
(right)

≥ 45°
(right/left)

To ensure maximum safety while working, the workpiece must always be firmly clamped.
Do not saw workpieces that are too small to clamp firmly.

  • Press the workpiece firmly against the fences (16) and (15).
  • Insert the supplied screw clamp (30) into one of the corresponding holes (45).
  • Adjust the threaded rod (65) of the screw clamp to the workpiece height.
  • Tighten the threaded rod (65) to fix the workpiece in place.