Adjusting mitre angles

  • Bring the power tool into the work position.

Setting Standard Mitre Angles (see figure H)

For quick and precise setting of commonly used mitre angles, detents (45) are provided on the saw table:

Left

Right

0°

45°; 30°; 22.5°; 15°

15°; 22.5°; 30°; 45°

  • Loosen the locking knob (11) if it is tightened.
  • Pull the lever (12) and rotate the saw table (10) left or right to the required detent.
  • Release the lever again. The lever must be felt to engage in the detent.
  • Retighten the locking knob (11).

Setting Any Mitre Angle (see figure H)

The mitre angle can be set between 47° (left-hand side) and 52° (right-hand side).

  • Loosen the locking knob (11) if it is tightened.
  • Push the lever (12), turn the saw table (10) left or right by the locking knob and set the required mitre angle using the angle indicator (13).
  • Retighten the locking knob (11).