Auxiliary handle
- Do not operate your power tool without the auxiliary handle (4).
This power tool must only be used with the auxiliary handle with the order number 1 602 025 07Y.
- Before carrying out any work, make sure that the auxiliary handle is tightened. Loss of control can cause personal injury. Ensure that the auxiliary handle is tightened with a torque suited to the fastening method; fasten this to the power tool so that any movement of the auxiliary handle around or along the drilling axis is avoided.
To open the auxiliary handle, turn the lower gripping end of the auxiliary handle (4) in an anticlockwise direction.
Pull back the intermediate piece of the auxiliary handle and hold it in this position.
Slide the auxiliary handle over the drill chuck to mount the auxiliary handle on the power tool.
Then let go of the intermediate piece .
Afterwards, turn the lower gripping end of the auxiliary handle (4) clockwise to retighten it.
You can swivel the auxiliary handle (4) to any angle for a safe work posture that minimises fatigue.
Turn the lower gripping end of the auxiliary handle (4) anticlockwise and swivel the auxiliary handle (4) into the required position. Afterwards, turn the lower gripping end of the auxiliary handle (4) clockwise to retighten it.
You can use the depth stop (3) to set the required drilling depth X.
Loosen the wing bolt for adjusting the depth stop (5) and insert the depth stop into the auxiliary handle (4).
Pull the depth stop (3) far enough out that the distance between the drill bit tip and the edge of the depth stop (3) corresponds to the required drilling depth X.
Retighten the wing bolt for adjusting the depth stop (5).