Product features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
(1) | Scale for spacing between saw blade and parallel guide |
(2) | Scale for spacing between saw blade and parallel guide when the saw table is pulled out |
(3) | Angle guide |
(4) | Saw table |
(5) | Guide groove for angle guide |
(6) | Protective cover |
(7) | Anti-kickback pawls |
(8) | Table insert |
(9) | Parallel guide |
(10) | Saw table expansion |
(11) | Recessed handles |
(12) | Parallel guide storage compartment |
(13) | Tilt protector |
(14) | Base unit |
(15) | Push stick |
(16) | Locking lever for setting the bevel angle |
(17) | Crank for raising and lowering the saw blade |
(18) | Hand wheel |
(19) | Safety flap for the on/off switch |
(20) | Saw table expansion clamping handle |
(21) | Push stick storage compartment |
(22) | Stop for 45° bevel angle |
(23) | Scale for bevel angle |
(24) | Stop for 0° bevel angle |
(25) | On button |
(26) | Restart button |
(27) | Riving knife |
(28) | Saw blade |
(29) | Angle guide storage compartment |
(30) | Cable holder |
(31) | Mounting holes on base unit |
(32) | Mounting holes |
(33) | Tool/anti-kickback pawls storage compartment |
(34) | Dust extraction adapter |
(35) | Ring spanner (10 mm; 13 mm) |
(36) | Hook spanner/open-ended spanner (10 mm) |
(37) | "Base unit" fastening set |
(38) | "Tilt protector" fastening set |
(39) | "Power tool" fastening set |
(40) | Riving knife bolt |
(41) | Recesses for table insert |
(42) | Anti-kickback pawls push button |
(43) | Clamping handle for parallel guide |
(44) | V guide for parallel guide |
(45) | V guide groove on the saw table for the parallel guide |
(46) | Guide groove for parallel guide |
(47) | Additional parallel guide |
(48) | "Additional parallel guide" fastening set |
(49) | Guide rail for angle guide |
(50) | Profile rail |
(51) | Profile rail wing nut |
(52) | Lower saw blade cover |
(53) | Fastening screws for lower saw blade cover |
(54) | Table insert gripping hole |
(55) | Clamping flange |
(56) | Saw blade hexagon screw |
(57) | Washer |
(58) | Mounting flange |
(59) | Angle indicator (vertical) |
(60) | Locking knob for all mitre angles |
(61) | Angle indicator on the angle guide |
(62) | Magnifying glass |
(63) | Saw table spacing indicator |
(64) | Cross-head screw for setting the 0° stop |
(65) | Screw for bevel angle indicator |
(66) | Cross-head screw for setting the 45° stop |
(67) | Hex socket screws (5 mm) on the front for adjusting the parallelism of the saw blade |
(68) | Hex socket screws (5 mm) on the rear for adjusting the parallelism of the saw blade |
(69) | Screw for saw table spacing indicator |
(70) | Hex socket screws (5 mm) for adjusting the parallelism of the parallel guide |
(71) | Screw for parallel guide spacing indicator |