Stationary or flexible mounting

To ensure safe handling, the power tool must be mounted on a flat, stable work surface (e.g. work bench) before use.

Assembly with base unit and tilt protector (see figures a1−a3)

For assembly, use the "base unit" (37), "tilt protector" (38) and "power tool" (39) fastening sets

Screw the base unit (14) together. Tighten the screws firmly.
Screw the tilt protector (13) to the base unit.
Place the power tool on the base unit so that the tilt protector points to the rear.
Attach the power tool to the base unit. For this, use the lateral holes (31) of the power tool as well as the holes in the base unit.

Assembly without base unit (see figure b)

Use a suitable screwed connection to secure the power tool to the work surface. The holes (32) are used for this purpose.