Fitting individual components

  • Carefully remove all parts included in the delivery from their packaging.
  • Remove all packing material from the power tool and the accessories provided.
  • Make sure that you remove the packaging material beneath the motor block.

The following parts of the tool are attached directly to the housing: Anti-kickback pawls (7), ring spanner (35), hook spanner/open-ended spanner (36), angle guide (3), parallel guide (9), additional parallel guide (47) with fastening set (48), protective cover (6), push stick (15), saw blade (28).

  • If you require one of these parts, remove it carefully from its storage location.

Note: If necessary, clean all parts to be fitted before you position them.

  • Remove the table insert (8) if necessary.
  • Turn the crank (17) clockwise as far as possible so that the saw blade (28) is in the highest possible position above the saw table.
  • Loosen the bolt (40) using the ring spanner (35).
  • Insert the riving knife (27) and push it down as far as possible.
  • Re-tighten the bolt (40) using the ring spanner (35).
  • Fit the table insert (8).

  • Hook the table insert (8) into the rear recesses (41) of the tool chamber.
  • Guide the table insert down.
  • Press down on the table insert until it engages in the front of the tool chamber.

In the event of a kickback, the anti-kickback pawls (7) prevent the workpiece from being flung towards the operator. The pawls' sharp teeth dig into the surface of the workpiece and hold it back.

  • Press the anti-kickback pawls' (7) pushbutton (42) together.
    This pulls back the guide pin.
  • Guide the anti-kickback pawls (7) over the riving knife (27) and release the pushbutton (42).
  • Slide the anti-kickback pawls towards the protective cover until the guide pin engages in the rear hole at the top of the riving knife.
  • Check that the guide pin is firmly connected to the hole and that the anti-kickback pawls are functioning properly. Carefully lift the anti-kickback pawls. When released, the spring-loaded pawls must go down and touch the table insert.

The parallel guide (9) can be positioned on either the left or the right of the saw blade.

  • Loosen the clamping handle (43) of the parallel guide (9). This lightens the load on the V guide (44).
  • First insert the parallel guide with the V guide into the guide groove (45) of the saw table. Then position the parallel guide in the front guide groove (46) of the saw table.
    The parallel guide can now be moved freely.
  • To secure the parallel guide, push the clamping handle (43) down.

To saw narrow workpieces and bevel angles, you must fit the additional parallel guide (47) on the parallel guide (9).
The additional parallel guide can be fitted on the left or right of the parallel guide (9) as required.

Use the "additional parallel guide" fastening set (48) (two fastening screws, two wing nuts) for fitting the guide.

  • Slide the fastening screws through the lateral holes on the parallel guide (9).
  • The heads of the screws are used to guide the additional parallel guide.
  • Slide the additional parallel guide (47) over the heads of the fastening screws.
  • Tighten the screws using the wing nuts.

  • Push the rail (49) of the angle guide (3) into one of the guide grooves (5) provided in the saw table.

To make it easier to position long workpieces, the angle guide can be extended with the profile rail (50).

  • If necessary, fit the profile rail on the angle guide using the wing nuts (51).