Auxiliary handle (see figure A)
- Do not operate your power tool without the auxiliary handle (12).
- Before carrying out any work, make sure that the wing bolt is tightened. Loss of control can cause personal injury.
Turn the wing bolt (11) anti-clockwise and guide the auxiliary handle (12) in the required position over the drill chuck onto the spindle collar of the power tool.
You can adjust the auxiliary handle (12) to any of 12 positions in order to achieve a safe work posture that minimises fatigue.
Turn the wing bolt for adjusting the auxiliary handle (11) anticlockwise and swivel the auxiliary handle (12) into the required position. Then retighten the wing bolt (11) by turning it clockwise.
Setting the drilling depth (see figure A)
You can use the depth stop (13) to set the required drilling depth X.
Press the button for depth stop adjustment (10) and insert the depth stop into the auxiliary handle (12).
Pull the depth stop (13) far enough out that the distance between the drill bit tip and the edge of the depth stop (13) corresponds to the required drilling depth X.
The fluting on the depth stop (13) must face upwards.