Practical Advice

Note: The cover (11) can only be closed securely if the Bluetooth® Low Energy Module GCY 42 and the coin cell are in the power tool.

  • To deactivate the Bluetooth® Low Energy Module GCY 42, turn the coin cell over or place a means of insulation between the coin cell and Bluetooth® Low Energy Module GCY 42.
  • Close the cover (11) to prevent dirt from getting in.

  • If the application tool jams or snags, the power transmission to the drill spindle will be interrupted. Always hold the power tool firmly with both hands to withstand the forces this may create and adopt a position with stable footing.
  • Switch the power tool off immediately and remove the application tool if the power tool becomes blocked. Switching on when the drilling tool is blocked may cause high torque reactions.

The rapid shut-off function (KickBack Control) gives the user greater control over the power tool and offers them better protection than power tools that do not have KickBack Control. If the power tool suddenly and unforeseeably rotates around the drilling axis, it will switch off, the rapid shut-off indicator (17) will light up red and the worklight (12) will flash. When rapid shut-off is activated, the status indicator (20) flashes red.

  • To switch the tool back on, release the on/off switch (9) and then press it again.

EPC assists you when drilling and when working with impact in sensitive materials by ensuring slow start-up of the operating speed for precise working.

For better control and precise positioning, the power tool starts at a low speed and then increases to the set speed.
Adapted Speed Control is started up automatically when the power tool is switched on.

The integrated vibration damping function reduces the generated vibration.

  • Do not continue to use the power tool if the damping element is damaged.