Product Features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
(1) | Carbon brush cover |
(2) | Speed preselection thumbwheel |
(3) | Handle (insulated gripping surface) |
(4) | Crank handle (3 x) |
(5) | Crank hub |
(6) | Overload indicator |
(7) | Laser on/off switch |
(8) | Rotational direction switch |
(9) | Motor on/off switch |
(10) | Magnetic base |
(11) | Holder for safety strap |
(12) | Tool holder |
(13) | Opening for MT2 drill drift |
(14) | Indicator for carbon brush change |
(15) | Portable residual current device |
(16) | Portable residual current device indicator |
(17) | Rail for coolant tank holder |
(18) | Release button for gear selector switch |
(19) | Gear selector switch |
(20) | Magnet on/off switch |
(21) | Magnet strength indicator |
(22) | Annular cutter adapter |
(23) | Screw tap adapterA) |
(24) | Screw tapA) |
(25) | Hex key (3/4/6 mm) |
(26) | Pilot pin |
(27) | Annular cutterA) |
(28) | Twist drill bit MT2A) |
(29) | Twist drill bit MT1A) |
(30) | Reduction sleeve (MT2/MT1) |
(31) | Twist drill bit with cylindrical shankA) |
(32) | Keyed chuck (up to a diameter of 16 mm)A) |
(33) | Taper mandrelA) |
(34) | MT2 drill drift |
(35) | Coolant tank |
(36) | Coolant tank holder |
(37) | Coolant hose |
(38) | Connector for cooling system |
(39) | Coolant valve |
(40) | Coolant tank screw cover |
(41) | Push-pull closure |
(42) | Ratchet |
(43) | Pawl on ratchet |
(44) | Safety strap |
(45) | Scale for drilling depth |
(46) | Drill unit |
(47) | Screws for guide rail |
(48) | Screws for gap adjustment |
(49) | Laser cover |
(50) | Laser beam output |
(51) | Clip |
(52) | Screw for laser adjustment (right/left) |
(53) | Screw for laser adjustment (forward/back) |
- A)
This accessory is not part of the standard scope of delivery.