Adjusting mitre angles

  • Bring the power tool into the work position.

Setting Standard Mitre Angles (see figure J)

For quick and precise setting of commonly used mitre angles, detents (15) are provided on the saw table:

Left

Right

0°

45°; 22.5°; 15°

15°; 22.5°; 45°

  • Loosen the locking knob (12) if it is tightened.
  • Press the lock button (11) down and turn the saw table (29) left or right by the locking knob until the angle indicator (14) shows the standard mitre angle required.
  • Release the lock button (11) again. The saw table must be heard to click into the detent.
  • Retighten the locking knob (12).

Setting any Mitre Angle

The mitre angle can be set between 47° (left-hand side) and 52° (right-hand side).

  • Loosen the locking knob (12) if it is tightened.
  • Press the lock button (11) down and turn the saw table (29) left or right by the locking knob until the angle indicator (14) shows the mitre angle required.
  • Release the lock button (11) again.
  • Retighten the locking knob (12).