Measuring functions

You will find the following functions in the Functions menu:

  • Length measurement
  • Continuous measurement
  • Area measurement
  1. Press the  button to open the Functions menu.
  2. Select the required measuring function with the  button.
  3. To confirm the selection, press the  button.

  1. Press the  button to open the Functions menu.
  2. Select the length measurement  and confirm the selection with the  button.
  3. Briefly press the  button to switch on the laser.
  4. Press the  button to start the measurement.
  5. The measured value is displayed in the result line (f) at the bottom of the display.
  6. Repeat the above-mentioned steps for each subsequent measurement.

If several length measurements are taken in a row, the results of the last measurements are displayed in the measured value lines (e). The last measured value is at the bottom of the display, the penultimate measured value is above it, and so on.

During continuous measurement, the measured value is continually updated. You can, for example, move a required distance away from a wall while reading off the current distance at all times.

  1. Press the  button to open the Functions menu.
  2. Select continuous measurement  and confirm the selection with the  button.
  3. The laser is permanently switched on.
  4. Move the measuring tool until the required distance is shown on the display.
  5. You can interrupt the continuous measurement by briefly pressing the  button.
  6. Press the  button again to continue the continuous measurement.

The current measured value is displayed in large figures for better readability.

Continuous measurement switches off automatically after 4 min.

  1. Press the  button to open the Functions menu.
  2. Select area measurement  and confirm the selection with the  button.
  3. Briefly press the  button to switch on the laser.
  4. Press the  button to start the first measurement, e.g. the length of a room.
  5. Press the  button to start the second measurement, e.g. the width of a room.

After the second measurement has been completed, the area will be automatically calculated and displayed. The result is displayed in the result line (f). The individual measured values are in the measured value lines (e).