Setting the Mitre Angle (see figure D)
The mitre angle can be set between 0° and 45°.
Important settings are marked with corresponding markings on the angle guide (6). The 0° and 45° positions are secured by the respective end stop.
- Loosen the locking screws (12) on the angle guide using the hex key (15) (8 mm) provided.
- Set the required angle and retighten both locking screws (12).
Moving the angle guide
If you want to cut wider workpieces, you can move the angle guide (6) backwards.
- Completely unscrew the locking screws (12) using the hex key provided (15) (8 mm).
- Move the angle guide (6) backwards by one or two holes to the required distance.
- Set the required angle and retighten both locking screws (12).