Start-up
- Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
Switching on (see figure K)
- To switch on the power tool, first slide the lock-off button (5) to the middle and then press and hold the on/off switch (29).
Note: For safety reasons, the on/off switch (29) cannot be locked; it must remain pressed during the entire operation.
Switching off
- To switch off, release the on/off switch (29).