Starting Operation
- Pay attention to the mains voltage! The voltage of the power source must match the voltage specified on the rating plate of the power tool. Power tools marked with 230 V can also be operated with 220 V.
- Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.
- Only push the rotational direction switch (5) when the power tool is not in use.
The rotational direction switch (5) is used to change the rotational direction of the power tool. However, this is not possible while the on/off switch (7) is being pressed.
Clockwise rotation: To drill and drive in screws, slide the rotational direction switch (5) downwards on the left-hand side and upwards on the right-hand side at the same time.
Anti-clockwise rotation: To loosen and unscrew screws and bolts, slide the rotational direction switch (5) upwards on the left-hand side and downwards on the right-hand side at the same time.
- Only operate the gear selector (9) when the power tool is not in use.
You can preselect two speed ranges with the gear selector (9).
Gear I:
Low speed range; for screwdriving or working with a large drilling diameter.
Gear II:
High speed range; for working with a small drilling diameter.
If the gear selector (9) cannot be swivelled all the way to the stop, turn the drive spindle slightly with the drill.
To start the power tool, press and hold the on/off switch (7).
Press the lock-on button (6) to lock the on/off switch (7) in this position.
To switch off the power tool, release the on/off switch (7); or, if the switch is locked with the lock-on button (6), briefly press the on/off switch (7) and then release it.