Starting Operation

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Switching On/Off

Make sure that you are able to press the On/Off switch without releasing the handle.

To switch on the power tool, tilt the on/off switch (1) toward the right to the “I” position.

To switch off the power tool, tilt the on/off switch (1) toward the left to the “O” position.