Operating modes
- Remove the battery from the power tool before carrying out work on the power tool (e.g. maintenance, changing tool, etc.). The battery should also be removed for transport and storage. There is risk of injury from unintentionally pressing the on/off switch.
The pendulum action can be adjusted using four different settings, allowing the cutting speed, cutting capacity and the cut itself to be optimally adapted to the material that you want to cut.
You can also adjust the pendulum action during operation using the adjusting lever (15).
Level 0 | No pendulum action |
Level I | Low pendulum action |
Level II | Moderate pendulum action |
Level III | High pendulum action |
The optimum pendulum level for each application can be determined by a practical test. Note the following recommendations:
- Select a lower pendulum level or switch off the pendulum action completely if you wish to produce a finer or cleaner cutting edge.
- Switch off the pendulum action when machining thin materials (e.g. sheets).
- Work on hard materials (e.g. steel) with low pendulum action.
- You can work on soft materials and saw wood using maximum pendulum action.
The base plate (12) can be swivelled to the right or left to make mitre cuts up to 45°.
The hood (19), the extraction outlet (20) and the anti-splinter guard (18) cannot be used while mitre/bevel cuts are being made.
- Push the extraction outlet (20) downwards slightly and pull it out of the base plate (12).
- Remove the hood (19) and the anti-splinter guard (18).
- Loosen the screw (22) with the hex key (11) and slide the base plate (12) slightly towards the rechargeable battery.
- To adjust mitre/bevel angles, swivel the base plate (12) to the required position according to the scale (23). Other mitre/bevel angles can be adjusted using a protractor.
- Then push the base plate (12) towards the saw blade (17) as far as it will go.
- Retighten the screw (22).
You can move the base plate (12) back for sawing close to edges.
Loosen the screw of the base plate (22) with the hex key (11) and slide the base plate (12) all the way towards the battery (8).
Retighten the screw (22).
Sawing with an offset base plate (12) is only possible with a mitre/bevel angle of 0°. In addition, the parallel guide with circle cutter (26) (accessory) as well as the anti-splinter guard (18) must not be used.
The cutting line can be kept clear of chips using the airflow from the sawdust blower device.
To switch on the sawdust blower device: When working with high material removal in wood, plastic and other similar materials, push the switch (14) towards the extraction outlet.
To switch off the sawdust blower device: When working in metal and with a dust extraction system connected, push the switch (14) towards the saw blade.