Start-up

• Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

• Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

• Check the cutting disc before using it. The cutting disc must be fitted properly and be able to rotate freely. Carry out a test run for at least 30 seconds with no load. Do not use cutting discs that are damaged, run untrue or vibrate during use. Damaged cutting discs can shatter and cause injuries.

Position of the operator (see figure F)

• Do not stand in front of the power tool in line with the cutting disc. Always stand to the side of the cutting disc. If the cutting disc breaks, your body is more protected from possible splinters in this position.

Switching on/off