Practical advice
- Do not touch the cutting disc after use until it has cooled. The cutting disc becomes very hot during use.
- Make sure that the spark guard plate (17) is fitted properly. Flying sparks are created when sanding metals.
Protect the cutting disc against impact, shock and grease. Do not subject the cutting disc to lateral pressure.
Do not load the power tool so heavily that it comes to a stop.
Excessive feed significantly reduces the performance of the power tool and the service life of the cutting disc.
Only use cutting discs that are suitable for the material being machined.
Maximum workpiece dimensions (in mm)
Workpiece shape | Mitre angle | |
|---|---|---|
0° | 45° | |
| Dia. 129 | Dia. 128 |
| 120 x 120 | 110 x 110 |
| 100 x 200 | 107 x 115 |
| 137 x 137 | 115 x 115 |
Minimum workpiece dimensions
(= all workpieces which can still be clamped in place with the locking spindle (7)): Length 80 mm
Maximum cutting depth (0°/0°): 129 mm
- Set the required mitre angle as necessary.
- Firmly clamp the workpiece as appropriate for its dimensions.
- Switch on the power tool.
- Slowly guide the tool arm downwards using the handle (2).
- Cut the workpiece, applying uniform feed.
- Switch off the power tool and wait until the cutting disc has come to a complete stop.
- Slowly guide the tool arm upwards.