Product features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
(1) | Guide groove for parallel guide |
(2) | Scale for spacing between saw blade and parallel guide |
(3) | Angle guide |
(4) | Recessed handles |
(5) | Guide groove for angle guide |
(6) | Protective cover |
(7) | Riving knife |
(8) | Saw table |
(9) | Parallel guide |
(10) | V guide groove on the saw table for the parallel guide |
(11) | Mounting holes |
(12) | Carrying handle |
(13) | Saw table expansion |
(14) | Fixing clip for the GTA 600 saw stand |
(15) | Clamping handle for saw table expansion |
(16) | Locking lever for setting the bevel angle |
(17) | Hand wheel |
(18) | Crank for raising and lowering the saw blade |
(19) | On/off switch safety flap |
(20) | Hex key (2 mm) |
(21) | Hex key (5 mm) |
(22) | Ring spanner (23 mm) |
(23) | Push stick |
(24) | Adjusting screw for adjusting the clamping force of the parallel guide |
(25) | Table insert |
(26) | Saw blade |
(27) | Magnifying glass |
(28) | Profile rail |
(29) | Cable holder |
(30) | Holding clip for storing the additional parallel guide |
(31) | Chip ejector |
(32) | Dust extraction adapter |
(33) | Bracket for storing the protective cover |
(34) | Clamping lever for riving knife |
(35) | Positioning pins for riving knife |
(36) | Recesses for table insert |
(37) | Clamping lever for protective cover |
(38) | Guide pin for protective cover |
(39) | Clamping handle of the parallel guide |
(40) | V guide of the parallel guide |
(41) | Additional parallel guide |
(42) | "Additional parallel guide" fastening set |
(43) | Guide rail of the angle guide |
(44) | "Profile rail" fastening set |
(45) | Fastening screw for chip ejector |
(46) | Clamping nut |
(47) | Spindle locking lever |
(48) | Clamping flange |
(49) | Tool spindle |
(50) | Mounting flange |
(51) | Bevel angle indicator |
(52) | Scale for bevel angles |
(53) | Locking knob for all mitre angles |
(54) | Angle indicator on the angle guide |
(55) | Saw table spacing indicator |
(56) | On button |
(57) | Knurled nut for profile rail |
(58) | Cross-head screw for setting the 0° stop |
(59) | Stop for 0° bevel angle |
(60) | Screw for bevel angle indicator |
(61) | Cross-head screw for setting the 45° stop |
(62) | Stop for 45° bevel angle |
(63) | Hex socket screws (5 mm) on the front for adjusting the parallelism of the saw blade |
(64) | Hex socket screws (5 mm) on the rear for adjusting the parallelism of the saw blade |
(65) | Screw for saw table spacing indicator |
(66) | Hex socket screws (5 mm) for adjusting the parallelism of the parallel guide |
(67) | Screw for parallel guide spacing indicator |
(68) | Adjusting screws for table insert |
(69) | Bracket for storing the "additional parallel guide" fastening set |
(70) | Holding clip for storing the dust extraction adapter |
(71) | Securing nut for the ring spanner and for hanging the push stick |
(72) | Bracket for storing the hex key |
(73) | Holding clip for storing the angle guide |