Auxiliary handle (see figure A)

Do not operate your power tool without the auxiliary handle (8).

Before carrying out any work, make sure that the auxiliary handle is tightened. Loss of control can cause personal in‌jury. The auxiliary handle is sufficiently tightened when it can no longer be moved towards the drilling axis.

Swivelling the auxiliary handle

You can swivel the auxiliary handle (8) to any angle for a safe work posture that minimises fatigue.

Turn the lower gripping end of the auxiliary handle (8) anticlockwise and swivel the auxiliary handle (8) into the required position. Afterwards, turn the lower gripping end of the auxiliary handle (8) clockwise to retighten it.

Setting the drilling depth

You can use the depth stop (6) to set the required drilling depth X.

Loosen the wing bolt for adjusting the depth stop (7) and insert the depth stop into the auxiliary handle (8).

Pull the depth stop (6) far enough out that the distance between the drill bit tip and the edge of the depth stop (6) corresponds to the required drilling depth X.