Starting Operation
- Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
The rotational direction switch (5) is used to change the rotational direction of the power tool. However, this is not possible while the on/off switch (3) is being pressed.
Clockwise rotation: For drilling and screwdriving, press the rotational direction switch (5) downwards to "R".
Anticlockwise rotation: For loosening and unscrewing screws and nuts, press the rotational direction switch (5) upwards to "L".
- Only operate the gear selector (2) when the power tool is not in use.
You can preselect two speed ranges with the gear selector (2).
| Gear I: Low speed range; for working with a large drilling diameter | |
| Gear II: High speed range; for working with a small drilling diameter. |
If the gear selector switch (2) cannot be swivelled all the way to the stop, turn the drive spindle slightly with the drill.