Changing the sanding sheet
Remove dirt and dust from the sanding plate , e.g. with a brush, before attaching a new sanding sheet.
To ensure optimum dust extraction, make sure that the punched holes in the sanding sheet are aligned with the drilled holes in the sanding plate.
Sanding sheets with hook-and-loop backing (see figure B)
If the sanding plate is fitted with a hook-and-loop fastening, sanding sheets with a hook-and-loop backing can be secured quickly and easily.
Tap the hook-and-loop fastening of the sanding plate before fitting the sanding sheet (17) to facilitate maximum adhesion.
Position the sanding sheet (17) so that it is flush with one side of the sanding plate , then place the sanding sheet on the sanding plate and press it on firmly.
To remove the sanding sheet (17), take hold of it by a corner and pull it away from the sanding plate .