Practical Advice
Shortly before the cordless worklight switches off because of an empty battery, it will flash three times and shine with reduced brightness.
The cordless worklight will flash five times just before it is about to switch off due to the time control.
You can adjust the time control via the app see Control Via App.
Errors – causes and corrective measures
Cause | Corrective measure |
|---|---|
A Bluetooth® connection cannot be established with the cordless worklight. | |
The cordless worklight is not emitting a Bluetooth® signal. | Remove the coin cell (11) and rechargeable battery (14) for 10 seconds. |
The cordless worklight cannot be operated via Bluetooth® even though the battery is inserted and charged. | |
The Bluetooth® module is not activated. | Press the on/off switch (1) repeatedly until the cordless worklight can be operated via Bluetooth®. |
The cordless worklight cannot be switched on after wireless charging. | |
The inductively chargeable battery has to be re-initialised. | Remove the rechargeable battery (14) for 10 seconds. |
The PIN for the Bluetooth® connection is not working. | |
The PIN must be reset to factory settings. | Remove the coin cell (11) and rechargeable battery (14) for 10 seconds. |