Inserting/removing the plastic bag (dry extraction) (see figure C)

Note: When removing and setting down the top part of the dust extractor (15), make sure that the rods of the bag holder (33) do not bend or break.

Open both catches (13) and remove the top part of the dust extractor (15).

For dry extraction, insert a plastic bag (36) into the container (12).

Insert the plastic bag (36) into the container (12) ➊ with the inlet facing upwards.

Make sure that the plastic bag (36) touches all the inside walls of the container (12) ➋.

Fold the rest of the plastic bag (36) over the edge of the container (12).

Put the top part of the dust extractor (15) back on ➌ and close the dust extractor using the catches (13).

Ensure that the dust extractor is always properly closed.

Note: Make sure when replacing the top part of the dust extractor (15) that you do not pierce the plastic bag (36) with the rods of the bag holder (33).

Seal the plastic bag before you remove it. To do this, remove the white strip from the plastic bag, hold the bag together at the top and use the strip to tie up the bag.