Wet Vacuuming

Do not use the vacuum cleaner to vacuum combustible or explosive liquids, such as petrol, oil, alcohol or solvents. Do not vacuum hot, burning or explosive dust. Do not operate the vacuum cleaner in areas subject to explosion hazards. Dust, vapours and liquids can ignite or explode.

The dust extractor must not be used without a filter.

Note: When removing and setting down the top part of the dust extractor (15), make sure that the rods of the bag holder (33) do not bend or break.

Before Starting Wet Extraction (see figure L)

Empty the container (12) and remove the plastic bag (36).

Press the detents (43) ➊ and remove the bag holder (33) ➋.

During and after wet vacuuming

The dust extractor is equipped with a float (44). Extraction is stopped when the maximum filling level is reached. The container (12) should then be emptied.

Note: If the container (12) is not emptied in a timely manner, the main filter (32) will also become filled with fluid. In this case, remove the main filter (32) and empty it as well see Cleaning/replacing filters.

After the work is complete, to prevent the formation of mould, remove the top part of the dust extractor (15) and the main filter (32) and allow both components to dry thoroughly.