Fitting the Vacuuming Accessories

The vacuum hose (20) is equipped with a clip system which can be used to connect vacuuming accessories (dust extraction adapter (21), curved nozzle (22)).

Fitting the extraction adapter or curved nozzle (see figure F)

Fit the extraction adapter (21) or the curved nozzle (22) to the vacuum hose (20) until the two snap fasteners (37) on the vacuum hose audibly click into place.

To remove the adapter, press the snap fasteners (37) inwards and pull apart the components.

Fitting the Nozzles and Tubes

If required, place the suction tubes (29) firmly inside one another and then attach them firmly to the curved nozzle (22).

Attach a floor nozzle (27)/(28), a crevice nozzle (25)/(26) or the brush (24) firmly to the suction tube (29) or the curved nozzle (22).