User interface
The user interface is used as follows:
- For switching the power tool on/off
- As the power tool status indicator
- As the battery charge indicator
- For resetting
Status indicators
Colour of the status indicator (2) | Meaning/cause | Solution |
|---|---|---|
Green | The power tool is ready for use. | – |
Yellow | Overheat protection: Motor or electronics are too warm. | Allow the power tool to cool down. If the motor and electronics are within the operating temperature, the power tool automatically returns to normal operation. |
Blue | Protection against cold: The power tool is too cold. | Allow the power tool to reach the correct temperature in a warm environment. If the motor and electronics are within the operating temperature, the power tool automatically returns to normal operation. |
Red | Jam detected: The firing pin cannot return to the correct position. | Clear the jam see Clearing Jams/Resetting. |
Orange | The motor is blocked: The firing pin cannot be moved into the correct position. | Clear the jam see Clearing Jams/Resetting. |
Cyan | Overcurrent protection: The motor is consuming too much power. | Check the power tool for jams or significant contamination and clear these see Clearing Jams/Resetting. If the error persists, contact an authorised after-sales service centre for Bosch power tools. |
Magenta | Maintenance is recommended: Error rate too high (e.g. bent nails or inadequate penetration depth) | Contact an authorised after-sales service centre for Bosch power tools. |
White | Electronics or sensor fault | The power tool has been put into safe mode and cannot be used. Contact an authorised after-sales service centre for Bosch power tools. |
Battery charge indicator (3) | Capacity |
|---|---|
5 × continuous green light | 80–100 % |
4 × continuous green light | 60–80 % |
3 × continuous green light | 40–60 % |
2 × continuous green light | 20–40 % |
1 × continuous green light | 5–20 % |
1 × flashing green light | 0–5 % |