Fitting and removing abrasive tools

Follow the special assembly instructions for X-LOCK application tools.

Pull the plug out of the socket before carrying out any work on the power tool.

Do not touch grinding and cutting discs until they have cooled down. The discs can become very hot while working.

Only use original X-LOCK application tools that carry the X-LOCK logo. A maintained clamping gauge of max. 1.6 mm can only be guaranteed with original X-LOCK application tools. A higher clamping gauge can lead to insecure clamping, potentially causing the clamp tool to come loose.

X-LOCK application tools do not need additional clamping flanges or support flanges.

Make sure that the application tool and the holder are not deformed and are free from dirt and particles.

Pay attention to the dimensions of the abrasive tools.

Make sure that both X-LOCK catches are open (see figure below) before fitting the X-LOCK application tool.

If necessary, clean the area between the two X-LOCK catches.

Fitting the abrasive tool

➊	Place the grinding/cutting/flap disc in a central position on the X-LOCK holder, parallel to the bearing surface and with the right side facing up.
➋	Push the disc into the holder.
➌	The disc audibly clicks into place. Do not actuate the lever (3) when doing so.

After fitting, check that the edge of the abrasive tool (➍) is fitted correctly, i.e. is no higher than the reference surface (➎). If the edge is higher than the reference surface, either the holder must be cleaned or the abrasive tool must not be used.

Before removing the grinding/cutting/flap disc: Make sure that the power tool has come to a complete stop.

➊	Open the lever (3).
➋	The grinding/cutting/flap disc will be released.
➌	The grinding/cutting/flap disc can be removed.