Documenting Measurements
The measuring tool begins to take measurements as soon as it is switched on and does so continuously until it is switched off.
To save an image, point the camera at the required measuring object and press the "Save" button (11). The image is saved in the internal memory of the measuring tool. Alternatively, press the measuring button (17) (pause). The measurement is frozen and shown in the display. This enables you to carefully view the image and to make retrospective adjustments (e.g. to the colour palette). If you do not wish to save the frozen image, restart measuring mode by pressing the measuring button (17). If you wish to save the image in the internal memory of the measuring tool, press the "Save" button (11).
Proceed as follows to call up saved thermal images:
- Press the left-hand function button (13). The most recently saved photo now appears in the display.
- Press the right-hand (8) or left-hand (12) arrow button to switch between the saved thermal images.
You can also display the thermal image taken as a full-screen image by pressing on the up arrow button (5).
In the <Delete All Images> menu, you can delete all the files in the internal memory at the same time. Press the Func (6) button to call up the measuring functions. Now press the right-hand function button (7) and select <Tool> → <Delete All Images>. Press the right-hand arrow button (8) to enter this submenu. Then press either the left-hand function button (13) to delete all files, or the right-hand function button (7) to cancel.