Assembling the drill stand
Position the drill column (20) so that it is vertical. Insert the lower screw (24) (see illustration on the graphics page). Tighten the lower screw (24) and the upper screw (21) using an open-ended spanner (width across flats 17 mm). Tighten the clamping nut (27) using an open-ended spanner (width across flats 24 mm).
Screw the three handlebars of the star handle (17) all the way into the central hub of the star handle.
The star handle (17) acts as the feed crank during drilling.
To drill, push the star handle all the way to the left or right (as required) and onto the feed pinion (28). Pull the star handle off firmly to remove it.
Before using for the first time, screw the locking brake (29) into the free threaded hole underneath the feed pinion (28).
Lock the feed when performing any work on the drill stand, during breaks and when not using the drill stand. Do this by engaging the locking brake (29).
To drill, loosen the locking brake (29) until the star handle (17) is easy to move. When doing so, hold the star handle in place to prevent the power tool from sliding down in an uncontrolled manner.