Setting the Routing Depth
Use the adjustment knob (19) to set the routing depth. The adjustment knob has lock-in heights for six sizes of jointing biscuit.
Assigning the lock-in heights to jointing biscuits and routing depths:
Lock-in height | Jointing biscuit | Routing depth in mmA) |
|---|---|---|
0 | No. 0 | 8 |
10 | No. 10 | 10 |
20 | No. 20 | 12.3 |
S | Simplex | 13 |
D | Duplex | 14.7 |
MAX | – | 22 |
- A)
achieved with a side milling cutter with a 105 mm diameter
The limit stop for the routing depth is set to an average. According to tolerances, when using resharpened side milling cutters or side milling cutters with a smaller diameter (< 105 mm), it may be necessary to readjust the routing depth. Do this by loosening the locking nut (20). Turn the adjusting screw (21) clockwise to reduce the routing depth or anticlockwise to increase it. Perform a test run to check the routing depth adjustment. Then retighten the locking nut (20) firmly.