Setting the Routing Angle

The angle guide (18) makes routing on mitres/bevels easier.

To adjust the angle guide (18), loosen the clamping lever (3). Tilt the angle guide until the required angle is set on the angle scale (5) (there are lock-in points at 0°, 30°, 45°, 60° and 90°). Then tighten the clamping lever (3).

Take care to ensure that neither the height-adjustable stop (9) nor the clip-on plate (17) are located in the exit area of the side milling cutter once the routing angle has been set. To check, switch the power tool off and push the router exit against the edge of a table, for instance, until the side milling cutter is visible. The most extended side milling cutter must not make contact with the height-adjustable stop (9) or the clip-on plate (17).