Starting Operation
You can adjust the feed rate of the rack (4) by pressing in the on/off switch (9) to varying extents.
You can preselect the maximum feed rate of the rack (4) with the feed rate thumbwheel (7). High values mean a high feed rate, low values mean a low feed rate. You can change the preselected value during operation.
The amount of material squeezed out also depends on the size of the dispensing nozzle opening.
To switch on the caulking gun, push the lock (10) down. Then press the on/off switch (9).
To switch off the caulking gun, release the on/off switch (9). The rack (4) moves immediately into the park position, in order to prevent further squeezing of the material.
If the on/off switch (9) is pressed again within approximately 10 s of switching off, the rack (4) moves to the last working position at maximum speed. If this position is achieved, the feed is adapted again to the adjusted feed rate.
To lock the on/off switch (9) against unintentional switching on, push the lock (10) up.