Starting Operation

  • Do not use the rotational direction switch (5) when the power tool is in operation, as this may damage it.

Clockwise rotation: To drive in screws, slide the rotational direction switch (5) forwards.

Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational direction switch (5) backwards.

There are 2 ways to switch on the power tool.

  • Exert pressure on the spindle and maintain this pressure to continue using the power tool. To switch it off, stop exerting pressure on the spindle.
  • Press the On/Off switch (4). To switch off, release the on/off switch (4).

To use the power tool as a manual screwdriver, slide the rotational direction switch (5) to the middle position.

This enables screws to be screwed in even when the battery is empty and allows the power tool to be used as a screwdriver.

The torque presetting ring (3) can be used to pre-select the required torque in 7 stages. Once the pre-selected torque has been reached, the tool will stop delivering power to the application.

Stage 1:
Lower torque for driving in screws with a small diameter or for use with soft materials.

Stage 7:
Higher torque for driving in screws with a large diameter or for use with hard materials.

In normal conditions of use, the power tool cannot be overloaded. If the power tool is overloaded or the permitted battery temperature is exceeded, the electronics of the power tool will switch off until the temperature returns to within the optimum operating temperature range.

The lithium-ion battery is protected against deep discharge by the "Electronic Cell Protection (ECP)". When the battery is discharged, the power tool is switched off by means of a protective circuit: The application tool no longer rotates.