Practical advice

A laser beam shows you the cutting line of the saw blade. This allows for exact positioning of the workpiece for sawing, without having to open the retracting blade guard.

  • To activate this, turn on the laser beam using the switch (38).
  • Align your mark on the workpiece with the right-hand edge of the laser line.

Note: Before sawing, check whether the cutting line is still indicated correctly. The laser beam can be misaligned due to vibrations from intensive use, for example.

Maximum workpiece dimensions:

Mitre angle

Bevel angle

Height x width [mm]

0°

0°

70 x 312

45° (right/left)

0°

70 x 225

0°

45°

45 x 312

45° (left)

45°

45 x 225

45° (right)

45°

45 x 225

Minimum workpiece dimensions (= all workpieces that can be secured left or right of the saw blade using the supplied screw clamps (28)): 100 x 40 mm (length x width)

Maximum cutting depth (0°/0°): 70 mm

The depth stop needs to be adjusted if you wish to saw a groove.

  • Swivel the depth stop (31) outwards.
  • Swivel the tool arm by the handle (9) into the required position.
  • Turn the adjusting screw (4) until the end of the screw touches the depth stop (31).
  • Slowly guide the tool arm upwards.

The length stop (35) (accessory) can be used for easily sawing workpieces of the same length.

The length stop can be mounted on either side of the saw table extension (13).

  • Loosen the locking screw (50) and move the length stop (35) over the clamping screw (51).
  • Re-tighten the locking screw (50).
  • Set the saw table extension (13) to the required length.

When sawing curved or round workpieces, these must be especially secured against slipping. At the cutting line, there should be no gap between the workpiece, fence and saw table.

If necessary, you will need to manufacture special fixtures.

The red insert plates (19) can become worn after prolonged use of the power tool.

Replace faulty insert plates.

  • Bring the power tool into the work position.
  • Loosen the screws (52) with a hex key (4 mm) and remove the old insert plates.
  • Insert the new right-hand insert plate.
  • Screw the insert plate as far as possible to the right with the screws (52) so that the saw blade does not come into contact with the insert plate over the entire length of the possible slide motion.
  • Repeat the work steps in the same manner for the new left-hand insert plate.