Fitting the 180 W angle head (see figure C)

These industrial cordless angle wrenches must be fitted with an adapter and a compatible angled screw head  see Technical Data first.

• Place the 180 W angle head on the adapter and tighten it with an open-ended spanner (16) against the spanner flat on the cap nut (14). Hold the open-ended spanner (17) against the spanner flat of the adapter (15).

• The thread and flange thread must be free from grease and the correct torque  see Technical Data must be used so that the angle head cannot come loose.

• Turn the lock nut (18) all the way back in the direction of the arrow a (left-hand thread).

• Then turn the adapter all the way back in the direction of the arrow a (left-hand thread).

• Never clamp the power tool to the housing shells.

• Turn the adapter back to the right until the angle head is in the required position, a maximum of 360°.

• Fix the adapter in this position by turning the lock nut (18) in the direction of the arrow c against the adapter using a suitable tool (hook spanner DIN 1810 form B size 25/28). Tighten the lock nut (18) to the correct tightening torque  see Technical Data. While doing so, you must hold with a suitable tool.

• The thread and flange thread must be free from grease and the correct torque  see Technical Data must be used so that the angle head cannot come loose.

• Hold the power tool with the open-ended spanner (17) against the spanner flat (15) of the adapter.